12.5 Gram 2 Part Epoxy Packet – White

These 12.5 Gram Epoxy white Ink Packets are ideal for in-field use and consists of two components, pre-measured in a two-part packet and separated by a single clip.

View the epoxy ink packet instructions here;

1. The clip is removed allowing the two sides to migrate.

2. The two components are mixed thoroughly by kneading and dispensed directly from the packet.

SURFACES: ceramics, phenolic, polyesters, melamine, silicone’s, ferrous and non-ferrous metals, glass, electronic parts DRYING TIME: dries to touch within 2 – 3 hours. Adding heat shortens curing time. Max. adhesion and chemical resistance takes 7 – 10 days. Requires addition of catalyst immediately before use.

The following are starting point guidelines to determine temperature and times to achieve a crosslinked ink film.

DRYING TIME – Room Temperature: ADE Series dries to touch in approximately 30-60 minutes and cures in 5-7 days.

Force-Drying/Curing: Baking ADE prints produces the hardest, most durable finish. Bake most ADE printed colors for approximately 10 minutes at a maximum range of 300°-325° F (150°-164°C). Temperatures above 325°F (164°C) may result in discoloration.

Meets Mil Spec: CID A-A-56032D Types I & III Formerly: MIL-I-43553b.

COLOR: White

COLOR SYSTEM: Pigment

SOLVENT SYSTEM: Glycol Either

Let us know if you need the Glass Plate, Ink Roller / Brayer and the type of marking device needed to complete your order.